DiagRA® Flash Station
The solution for simultaneously
flashing 20 control units.
DiagRA® Flash Station
DiagRA® Flash Station is the flashing tool which lets you flash up to 20 control units on separate CAN or CAN FD vehicle buses. In the case of DoIP, the control devices can be operated together in a subnet or each control device in its own subnet. In a shared subnet, the control units are uniquely identified due to their Entity Identification EID. When using one subnet per control unit, unique identification is guaranteed via the EID or via the control unit’s IP address. You decide which of the connected control units should be flashed.
Your Benefits
Make use of all the advantages – wherever you are. Save valuable time by flashing 20 control units at the same time.
Check Flash Process
Check the current status of the flashing process during runtime.
Time-Efficient Flashing
Flash up to 20 control units at the same time.
Inexpensive
No need for expensive specialized solutions.
Parallel Flashing as a benefit
Save valuable time by flashing 20 control units simultaneously. A flashing time of 3 minutes per control unit, for a total of 60 minutes. Flashing the control units at the same time saves approximately 50 minutes, as the entire flashing process only takes about 7 minutes. It’s up to you whether you flash individual control units, a group of control units, or all of them. Change the settings for individual control units or directly for the entire group. Control DiagRA® Flash Station in basic mode or easily change to advanced mode.
Feature Overview
DiagRA® Flash Station lets you run the most efficient and simple flashing process.
Flashing Several Control Units
DiagRA® Flash-Station enables the parallel flashing of up to 20 control units.
Different Operating Modes
DiagRA® Flash Station offers a basic and advanced mode.
Flash UDS, CAN FD and DoIP
DiagRA Flash Station is suitable for flash programming via UDS on CAN, CAN FD and DoIP.
DiagRA® Flash Station Supports:
| Standards | SAE J1979, SAE J1939, ISO 27145, ISO 14229 |
| Interfaces | SocketCAN, PEAK, Kvaser, SAE J2534 PassThru, RP120, DoIP |
| Physical Connection | CAN, CAN FD |
| Flash Formats | HEX/S19, ODX |
DiagRA® Flash Station
Enables up to 20 control units to be flashed simultaneously with an intuitive, modern user interface or integrated into existing environments such as EOL.
Technical Specification
| Standards | SAE J1979, SAE J1939, ISO 27145, ISO 14229 |
| Interfaces | SocketCAN, PEAK, Kvaser, SAE J2534 PassThru, RP120, DoIP |
| Physical Connection | CAN, CAN FD |
| Flash Formats | HEX/S19, ODX |
| System requirements Linux from Kernel 4.4 | Processor: ARM 32/64 bit, Intel 32/64 bit Main memory: from 512 MB Hard disk: 512 MB (developer version), 30 MB (application via web services, e.g. Flashhub) Interface: SocketCAN-compatible interface (Kvaser, PEAK, …) |
| System requirements from Windows 7 | Processor: Intel 32/64 bit Main memory: from 4 GB Hard disk: 512 MB (developer version), 30 MB (application via web services, e.g. Flashhub) Interface: Kvaser, PEAK, Passthru |